Dacia Striker

a hoy

Switch A is used to adjust the height of the headlight beams according to the load.

With the dipped beam headlights on, press or raise switch A as many times as required to select the required position on the instrument panel.

The position selected is displayed on the instrument panel for approximately 30 seconds.

Note: depending on the vehicle, each time the ignition is switched on, the position selected is displayed on the instrument panel for approximately 30 seconds and for approximately five seconds each time switch A is pressed.

Table of adjustment position examples

Examples of positions for adjusting the control A according to the load

2WD combustion engine versions

Hybrid 4x4 versions

Hybrid2WD versions

Driver alone or with front passenger

0

0

0

Driver with one front passenger and three rear passengers

1

1

1

Driver with one front passenger, three rear passengers and luggage (or load) reaching the maximum permissible all-up weight

2

2

2

Driver only with luggage (or cargo) reaching the maximum permissible all-up weight

3

3

3

The table below gives some examples. In all cases, adjust the control A according to the vehicle load so that the road can be seen and other drivers are not dazzled.