Dacia Bigster
Installation visual for the five-door, five-seat version
Seat not suitable for fitting child seats.
Child seat attached using the mounting ISOFIX
Seat which allows an ISOFIX child seat to be fitted.
The rear side seats are equipped with an anchorage point allowing a forward-facing ISOFIX child seat with “Universal” approval to be attached. The anchorage points
are located in the boot and are visible.
warning
Check that your child is always strapped in and that the belt or safety harness used is correctly set and adjusted Seat belts.
If necessary, adjust the seat position accordingly.
warning
Using a child safety system which is not approved for this vehicle will not properly protect the baby or child. They risk serious or even fatal injury.
warning
It is prohibited to fit a child seat in the adjacent available seat when the seatback is folded down onto the other seats Rear seats.
Installation table
The table below summarises the information shown on the installation diagram in order to ensure the regulations in force are respected.
Type of child seat | Weight of the child | Size of seat [fixture] | Front passenger seat | Rear seats | ||
|---|---|---|---|---|---|---|
With airbag that cannot be deactivated | Without airbag or airbag deactivated | Side seats | Centre seat | |||
Carrycot fitted across the vehicle Approved for group 0 | < 10 kg | L1 [F], L2 [G] | X | X | X | X |
Rear-facing shell seat Approved for group 0 or 0+ | < 13 kg | R1 [E] | X | X | IL (1) | X |
Rear-facing seat Approved for group 0+ or 1 | < to 13 kg and 9 to 18 kg | R2 [D], R2X [D] | X | X | IL (1) | X |
R3 [C] | X | X | X | X | ||
Forward-facing seat Approved for group 1 | 9 kg to 18 kg | F3 [A], F2 [B], F2X [B1] | X | X | IUF-IL(1) (2) | X |
Booster seat Approved for group 2 or 3 | 15 kg to 25 kg and 22 kg to 36 kg | B2 | X | X | IUF-IL(1) (2) | X |
| B3 | X | X | X | X | ||
Seati-Size | Rear-facing seat | X | X | i-U(1) | X | |
Forward-facing seat | X | X | i-UF(1) (2) | X | ||
Booster seat | X | X | i-UF(1) (2) | X | ||
Refer to the "Child safety equipment" booklet available from the network to choose the seat suited to your child and recommended for your vehicle.
X = Seat not suitable for fitting child seats.
IUF = Seat which allows forward facing child seats with "Universal" approval to be attached using ISOFIX attachments: check that it can be fitted.
IL = Seat which allows child seats with "Semi-universal" or "Vehicle specific" approval to be attached using ISOFIX attachments; check that it can be fitted correctly.
i-U = Suitable only for "Universal" front-facing and rear-facing i-Size restraint systems: check that it can be fitted.
i-UF Suitable for "Universal" front-facing and rear-facing i-Size restraint systems: check that it can be fitted.
(1) In order to install a rear-facing child seat, move the front seat as far forward as possible, then move the front seat back as far as it will go without allowing it to come into contact with the child seat.
(2) Always retract the headrest of the rear seat on which the child seat is positioned. This action must be performed before fitting the child seat Rear headrests. Move the seat in front of the child forwards, move the seatback forward to avoid contact between the seat and the child's legs.
The size of the ISOFIX child seat is indicated by a letter:
- F3 [A], F2 [B],F2X[B1]: for forward-facing seats in Group 1 (9 to 18 kg);
- R2 [D], R2X [D], R3 [C]: rear-facing seats or shell seats in Group 0+ (less than 13 kg) or Group 1 (9 to 18 kg);
- R1 [E] rear-facing shell seats in Group 0 (less than 10 kg) or 0+ (less than 13 kg);
- L1 [F], L2 [G]: carrycots in group 0 (less than 10 kg);
- B2, B3: booster seats in Groupe 2 and 3 (15 to 25 kg and 22 to 36 kg).