Dacia Jogger
Front headlights: replacing the bulbs
Main beam headlight 1
Remove the cover A.
Unclip the connector 2, remove the assembly from its housing and take out the bulb.
Bulb type: H7.
Before replacing the bulb, make a careful note of its position in its housing. After changing it, check that the replacement bulb is in exactly the same position in the housing. Clip the cover in place.
Dipped beam headlight 3 ( LED )
Consult an approved Dealer.
Daytime running light/side light 4 ( LED )
Consult an approved Dealer.
Direction indicator light 5 ( LED )
Consult an approved Dealer.
warning
Please note when working close to the engine that it may be hot. The engine cooling fan may also start at any moment. The
label in the engine compartment reminds you of this.
Risk of injury.
Front fog lights 6
Because of their reduced accessibility, we advise you to have your bulbs replaced by an approved Dealer.
- Access the bulb holder by unclipping the flap 7;
- turn the bulb holder by a quarter of a turn;
- remove the bulb.
Bulb type: H16LL.
Additional lights
If you wish to fit fog lights to your vehicle, please consult an authorised dealer.
Rear and side lights
Side/fog lights, direction indicator lights, brake lights and reversing lights
(depending on the vehicle)
Open the luggage compartment door and remove covers A and B.
Loosen bolts 1 and 2 (using a screwdriver or similar tool), then remove the rear light unit from outside the vehicle.
Pull the tabs 3 to unclip the bulb holder.
To refit it, carry out the above operations in reverse order.
Check the tabs are correctly locked in position.
- 4.
Brake light
Bulb type 4: P21W.
- 5.
Reversing light
Bulb type 5: P21W.
- 6.
Direction indicator light
Bulb type 6: PY21W
- 7.
Side light/fog light
(depending on the vehicle)
Bulb type 7: P21W.
- 8.
Daytime running light/side light 8 with LED
High level brake light 9
Using a flat-blade screwdriver or similar tool, carefully unclip the brake light 9 while pressing on the upper surface of the brake light (movement C). Disconnect the brake light.
Access the bulb 10.
Bulb type 10: W16W.
To refit, position the brake light on the spoiler.
Press the upper edge of the part (movement D) then push the screen of the light in the areas where the clips are located until it clicks (movement E).
However, because of their reduced accessibility, we advise you to have your bulb replaced by an approved Dealer.
Number plate lights 13
Unclip the light 13 by pressing the tab 11 using a flat-blade screwdriver or similar tool.
Unclip the lens 12 and remove the bulb 14.
Bulb type: W5W.
LED number plate lights 13
(depending on the vehicle)
Consult an approved Dealer.
Indicator lights 15
Unclip the direction indicator light 15 using a flat-blade screwdriver or similar tool positioned at F to lever the direction indicator light towards the outside of the vehicle.
Make a quarter of a turn (movement G) on the bulb holder 16 and remove the bulb 17 (movement H).
Bulb type: WY5W.
Replace the bulb and refit the direction indicator light.
