The driver vigilance warning is a function that analyses the behaviour of the driver (driving style, vehicle steering, etc.) and alerts them if there is a risk of falling asleep.

It takes into account indicators such as:

  • steering wheel movements;
  • driver actions on other systems (indicators, brake pedal, etc.).
warning

This function is an additional driving aid in case of risk of fatigue. The function does not operate on the vehicle. The function cannot, under any circumstances, replace the driver's responsibility during driving.

The driver must always adapt their driving according to their alertness, regardless of the system's indications.

Operation

12007_P1310_001_2_image.jpeg

The function is set to notify the driver if:

  • a few minutes have elapsed since the vehicle last stopped;
  • the vehicle speed is greater than approximately 43 mph (70 km/h).

If there is a risk of fatigue or impaired attention, the "Vigilance alert Have a break" message is displayed on the instrument panel accompanied by a beep.

Press switch 1 "OK" to delete the warning. It is advisable to stop as soon as possible for a break.

After deleting the message, the system continues vigilance monitoring and issues a new warning if necessary.

tip

The driver vigilance warning constantly monitors the driver's attention and can provide several warnings per journey.

The system resets every time the engine is started.

Warning activation/deactivation

warning

For safety reasons, carry out any adjustments while the vehicle is stationary.

tip

Depending on the vehicle, depending on the length of time following the last time the engine was stopped, the alerts are reactivated:

  • when the vehicle is unlocked;

or

  • when a door is opened;

or

  • when the engine is restarted.
tip

When the alerts are deactivated, the system continues to assess the driver's state of fatigue.

Activating, deactivating alerts using the 2 "My Safety" button

12044_P1310_001_1_image.jpeg

The alerts can be deactivated or activated using "Perso" mode in the "My Safety" function My Safety.

If the alerts have previously been deactivated using "Perso" mode:

  • to deactivate the alerts, press the button 2 twice. The indicator light on the button 2 goes out;
  • to reactivate alerts, press the button 2 once. The indicator light on the button 2 lights up.

Activating and deactivating the alerts from the multimedia screen 3

To activate or deactivate the alerts, please refer‑to the multimedia instructions.

Choose "ON" or "OFF".

Activating, deactivating the alerts from the trip computer 4

(depending on the vehicle)

12003_P1310_001_2_image.jpeg

  • With the vehicle stationary, press switch 5 as many times as required to reach the 2_ALL_416_1_pictogramme.png  tab;

or

  • press switch 5 and repeatedly press control 6 or 7 to reach the 3_ALL_038_1_pictogramme.png  menu;
  • press switch 8 "OK";
  • repeatedly press control 6 or 7 to reach the 3_ALL_108_1_pictogramme.png menu, then press the switch 8 "OK";
  • repeatedly press control 6 or 7 to reach the "DRIVING ASSIST" menu, then press switch 8 "OK";
  • repeatedly press control 6 or 7 to reach the "Vigilance warning" menu, then press switch 8 "OK";
  • press the 8 "OK" switch again to activate or deactivate the alerts:
    • 2_ALL_503_1_pictogramme.png warnings enabled;
    • 2_ALL_502_1_pictogramme.png warnings deactivated.

Limitations of system operation

Some conditions can disrupt or damage the operation of the system, for example:

  • certain driving styles (incorrect driving);
  • driving on a road in poor condition;
  • strong side wind;
  • the clock is wrongly configured (depending on vehicle) Clock and outdoor temperature;
  • winding roads;
  • trailer traction.

Operating faults

If the system detects a fault, the "Vigilance monit. to check" message and the 3_ALL_014_1_pictogramme.png warning light are displayed on the instrument panel.

Have the system checked by an authorised dealer.