Introduction

warning

This function is an additional driving aid in case of a risk of distraction. The function does not operate on the vehicle. The function cannot, under any circumstances, replace the driver's responsibility during driving.

The driver must always adapt their driving according to their alertness, regardless of the system's indications.

The system analyses the behaviour of the driver's face using the interior camera 1 and emits a warning if any distraction is detected.

A distraction is when a driver doesn't look at the road for about three seconds or repeats this movement several times in a row.

Note: the system does not record any images and operates in real time.

Location of the camera 1

Make sure that the camera is not obscured (by dirt, fogging, etc.) or covered.

Operation

tip

The system continuously monitors the driver's attention and can issue several warnings during a journey.

The function is ready to warn you when the speed is above approximately 12 mph (20 km/h).

In the case of distraction, the "Remain focused on driving" message is displayed on the instrument panel 2 accompanied by a beep.

Press the 3 "OK" switch to clear the warning light displayed on the instrument panel. After deleting the message, the system continues to monitor distraction and issues a new warning if necessary.

Activation/deactivation

warning

For safety reasons, carry out any adjustments while the vehicle is stationary.

tip

Depending on the vehicle, according to the length of time following the last time the engine was stopped, the alerts are reactivated:

  • when the vehicle is unlocked;

or

  • when a door is opened;

or

  • when the engine is started.
tip

Depending on the vehicle, it may not be possible to deactivate alerts.

Depending on the vehicle, the alerts can be activated or deactivated using:

  • the "My Safety" button;
  • the multimedia screen;
  • the on-board computer.

Activating and deactivating alerts using the "My Safety" button 4

The alerts can be deactivated or activated using "Perso" mode in the "My SafetyMy Safety.

If the alerts have previously been deactivated using "Perso" mode:

  • to deactivate the alerts, press the button 4 twice. The indicator light on the button 4 goes out;
  • to reactivate alerts, press the button 4 once. The indicator light on the button 4 lights up.

Activating and deactivating the alerts from the multimedia screen 5

To activate or deactivate the alerts, please refer‑to the multimedia instructions.

Select "ON" or "OFF".

Activating and deactivating the alerts from the on-board computer 2

(depending on the vehicle)

  • With the vehicle stationary, press the switch 6 as many times as required to reach the  3_ALL_038_1_pictogramme.png tab or, depending on the vehicle, the 2_ALL_416_1_pictogramme.png  tab;

or

  • press switch 6 and repeatedly press control 7 or 8 to reach the 3_ALL_038_1_pictogramme.png  tab;
  • depending on the vehicle, press the "3 OK" switch;
  • repeatedly press control 7 or 8 to reach the 3_ALL_108_1_pictogramme.png menu, then press the 3 "OK" switch;
  • repeatedly press control 7 or 8 to reach the "DRIVING ASSIST" menu, then press the 3 "OK" switch;
  • repeatedly press control 7 or 8 to reach the "Distraction alert" menu, then press the 3 "OK" switch;
  • press the 3"OK" switch again to activate or deactivate the warnings:
    • 2_ALL_503_1_pictogramme.png alerts activated;
    • 2_ALL_502_1_pictogramme.png alerts deactivated.

Limitations of system operation

Some conditions can disrupt or damage the system operation, for example:

  • when wearing certain types of glasses;
  • if the camera is obstructed, even partially;
  • if part of the driver's face is hidden (by hair, a cap, surgical mask, scarf, etc.).
  • an unsuitable driving position (such as sitting too low, leaning too far back, etc.) that can prevent the camera from properly analysing the face.

In these conditions, the system may either not trigger a warning or it may trigger untimely or false warnings.

Operating faults

If the system detects an operating fault, the "Vigilance monit. to check" message or, depending on the vehicle, the "Attention monitoring unavailable Face not detected" message appears, accompanied by the 3_ALL_014_1_pictogramme.png warning light, on the instrument panel.

Check that the camera is clean and/or remove any face-covering accessories. Make sure you are seated correctly. If there is still a problem, contact an approved Dealer.