Switch A is used to adjust the height of the headlight beams according to the load.

With the dipped beam headlights on, press or raise switch A as many times as required to select the required position on the instrument panel.

The position selected is displayed on the instrument panel for approximately 30 seconds.

Note: depending on the vehicle, each time the ignition is switched on, the position selected is displayed on the instrument panel for approximately 30 seconds and for approximately 5 seconds each time switch A is pressed.

Table of adjustment position examples

Examples of positions for adjusting the control A according to the load

4x4 Combustion versions

4x2 Combustion versions

Hybrid4x4 versions

Hybrid4x2 versions

Driver alone or with front passenger

0

0

0

0

Driver with one front passenger and three rear passengers

1

1

1

1

Driver with one passenger in the front, three passengers in the back, and baggage (or load) reaching the maximum permissible all-up weight

2

2

2

2

Driver only and with luggage (or load) reaching the maximum authorised load weight

3

3

3

3

The table below gives some examples. In all cases, adjust the control A according to the vehicle load so that the road can be seen and other drivers are not dazzled.