Multimedia system

The presence and location of this equipment depends on the vehicle’s multimedia equipment.

1.

Multimedia screen.

2.

Multimedia sockets USB‑C in the centre console.

3.

Accessories socket Accessories socket, ashtray, cigarette lighter.

4.

Steering column control.

5.

Voice command.

6.

Multimedia socket.

7.

Multimedia sockets USB‑C for the rear passengers (depending on the vehicle).

warning

Using the telephone

We remind you of the need to conform to the legislation in force concerning the use of such equipment.

warning

Connect accessories with a maximum power of 12 watts only.

Fire hazard.

Multimedia port

Multimedia sockets USB‑C2 and 7 (depending on the vehicle) can be used to charge accessories with a maximum power of 12 Watts (5 Volts) per socket.

Note: the multimedia sockets USB‑C2 can also be used the transfer data.

tip

If you connect a cable from an accessory to a USB port (e.g. a smartphone charging cable), be sure to disconnect it when no longer needed.

Risk of short circuit and damage to the USB port in the event of contact between the end of the cable and a metallic object (e.g. cigarette lighter, etc.).

tip

Please refer to the multimedia instructions for further information.

Hands-free telephone integrated control

Use the microphone 8 and the steering column control 4.

warning

Using the telephone

We remind you of the need to conform to the legislation in force concerning the use of such equipment.

Induction charging area 9

Passenger compartment storage, fittings.

Phone holder A

On vehicles that are equipped, lift the flap 10, place your phone 13 horizontally onto the stand 11 then lower the flap 10 while keeping the phone in position on the stand 12.

warning

For safety reasons, carry out any adjustments while the vehicle is stationary.

Make sure that the telephone is securely held in place between the 11 and 12 stands before use.

warning

Make sure that the telephone is securely held in place in the telephone holder to ensure that it is not thrown onto the occupants during sudden turning or braking.

warning

Using the telephone

We remind you of the need to conform to the legislation in force concerning the use of such equipment.

Removable phone holder B

On vehicles that are equipped, to fit the removable telephone holder B, observe the following instructions:

On vehicles that are equipped, to fit the removable telephone holder B, observe the following instructions:

  • remove the cover 18 (movement C);
  • attach the base 15 of the telephone holder to the component 19 (movement D);
  • pull the clamp 16 to the left;

  • place your telephone in the telephone holder 14 pressing the fixed clamp 17, then release the clamp 16 so that the telephone is firmly held in place between clamps 16 and 17.

To remove the removable telephone holder B, proceed in the reverse order.

Note: You can manually adjust the tilt of the telephone holder 14 to the desired position.

warning

Make sure that the base of the telephone holder is correctly fitted and that the telephone is securely held in place in the telephone holder, so that it is not thrown onto the occupants during sudden turning or braking.

warning

For safety reasons, carry out any adjustments while the vehicle is stationary.

warning

Using the telephone

We remind you of the need to conform to the legislation in force concerning the use of such equipment.