Multimedia system

13016_P1310_001_2_image.jpeg

The presence and location of this equipment depends on the vehicle’s multimedia equipment.

1.

Multimedia screen.

2.

Multimedia sockets USBC in the centre console A or B.

3.

Accessories socket Accessories socket.

4.

Steering column control.

5.

Voice command.

6.

Multimedia sockets USBC for the rear passengers.

warning

Using the telephone

We remind you of the need to conform to the legislation in force concerning the use of such equipment.

warning

Connect accessories with a maximum power of 12 watts only.

Fire hazard.

Multimedia port

13016_P1310_002_1_image.jpeg

The multimedia sockets USBC2 and 6 can be used to charge accessories with a maximum power of 12 Watts (5 Volts) per socket.

Note: the multimedia sockets USBC2 can also be used the transfer data.

tip

If you connect a cable from an accessory to a USB port (e.g. a smartphone charging cable), be sure to disconnect it when no longer needed.

Risk of short circuit and damage to the USB port in the event of contact between the end of the cable and a metallic object (e.g. cigarette lighter, etc.).

tip

Please refer to the multimedia instructions for further information.

Hands-free telephone integrated control

13016_P1310_017_1_image.jpeg

Use the microphone 7 and the steering column control 4.

warning

Using the telephone

We remind you of the need to conform to the legislation in force concerning the use of such equipment.

Induction charging area 8

13016_P1310_005_1_image.jpeg

Passenger compartment storage, fittings.

tip

When driving, make sure that the container held by the cup holder is properly closed so that it does not tip over.

Risk of damage to surrounding electrical and/or electronic equipment in the event of liquid spillage.

Phone holder C

On vehicles that are equipped:

  • open the lower flap 10;
  • lift the flap 9;
  • place your phone 13 in a horizontal position in the slide 12, then;
  • lower the flap 9 while positioning the phone in the slide 11.

warning

For safety reasons, carry out any adjustments while the vehicle is stationary.

13016_P1310_008_2_image.jpeg

Make sure that the telephone is securely held in place between the 11 and 12 stands before use.

warning

Make sure that the telephone is securely held in place in the telephone holder to ensure that it is not thrown onto the occupants during sudden turning or braking.

warning

Using the telephone

We remind you of the need to conform to the legislation in force concerning the use of such equipment.

Removable phone holder D

On vehicles that are equipped, to fit the removable phone holder D, observe the following instructions:

  • press button 14 on the phone holder D;

  • attach the base 15 of the phone holder to the multi-accessory holder YouClip16;
  • pull the clamp 19 to the right;

13016_P1310_011_1_image.jpeg

  • place your telephone in the telephone holder 18 pressing the fixed clamp 17, then release the clamp 19 so that the telephone is firmly held in place between clamps 17 and 19.

To remove the removable phone holder D, press button 14.

Note: You can manually adjust the tilt of the telephone holder 18 to the desired position.

Only use the telephone holder approved by the Technical Department.

warning

Make sure that the base of the telephone holder is correctly fitted and that the telephone is securely held in place in the telephone holder, so that it is not thrown onto the occupants during sudden turning or braking.

warning

For safety reasons, carry out any adjustments while the vehicle is stationary.

warning

Using the telephone

We remind you of the need to conform to the legislation in force concerning the use of such equipment.