Dacia Striker
Introduction
Ultrasonic sensors, indicated by arrows 1, are fitted in the bumpers to detect obstacles near the vehicle.
The function alerts the driver via audible signals and a display representing the area where the obstacle was detected.
Depending on the equipment, the system detects obstacles behind, in front and to the sides of the vehicle.
The parking distance control system is only activated when the vehicle is driven at a speed below approximately 6 mph (10 km/h).
The function does not take into account towbar or carrying systems that are not recognised by the system.
warning
This function is an additional driving aid.
Under no circumstances should it replace the driver's vigilance or responsibility during manoeuvres.
The driver must always remain alert to sudden events that may occur while driving: always ensure that there are no moving obstacles or small or thin obstacles (such as a child, an animal, a pushchair, a bicycle, a stone, a post, etc.) in the blind spot when manoeuvring.
warning
In the event of an impact to vehicle subframe during a manoeuvre (e.g. contact with a post, a raised kerb or any other street furniture) the vehicle may be damaged (e.g. deformation of an axle).
To avoid any risk of accident, have your vehicle checked by an Approved Dealer.
Location of the ultrasonic sensors1
Ensure that the area around the ultrasonic sensors indicated by the arrows 1 is not obscured (by dirt, mud, snow, a badly fitted/attached number plate), impacted, modified (including paintwork) or obstructed by any accessory fitted to the rear and/or, depending on the vehicle, to the front or sides of your vehicle.
Operation
The screen 2 shows the vehicle surroundings, accompanied by beeps.
Depending on the equipment, it may be necessary to travel a few metres before the side detection is activated.
If all areas have a grey background, the whole area around the vehicle is being monitored:
- display A: analysis of the vehicle surroundings in progress;
- display B: analysis of the vehicle surroundings complete.
Obstacle detection
The system is able to detect most obstacles located near the rear and, depending on the equipment, near the front and sides of the vehicle.
The audible signal frequency will increase as the vehicle approaches an obstacle, until it becomes a solid beep at approximately 20 cm for an obstacle detected on the sides and approximately 30 cm for an obstacle detected to the front or rear.
The area where the obstacle has been detected is displayed (display C). Depending on the vehicle, the area is displayed in green, orange (or yellow depending on the vehicle) or red, depending on the proximity of the detected obstacle.
tip
In the event of a change in trajectory during a manoeuvre, the risk of collision with an obstacle may be signalled late.
Special case of obstacles detected on the side
Depending on the direction of the wheels, the system determines the trajectory of the vehicle and notifies the driver if there is a risk or not of a collision with an obstacle 3 to the side of the vehicle.
If a side obstacle is detected:
- the beeps become faster and then sound continuously as the obstacle gets nearer. The area where the obstacle 3 has been detected is displayed (display D);
- if there is no risk of collision, no beep will sound when approaching the obstacle. Depending on the vehicle, the area where the obstacle 3 has been detected is displayed hatched.
tip
In the event of a change in trajectory during a manoeuvre, the risk of collision with an obstacle may be signalled late.
Activating/deactivating the system from the multimedia screen 4
From the "Vehicle" world on your multimedia screen 4, press the "Parking assistance" menu.
Activate or deactivate areas covered by the ultrasonic sensors.
Please refer to the multimedia instructions for further information.
Note: depending on the vehicle, the "rear" detection zone cannot be deactivated.
Automatic deactivation of parking distance control
The system is deactivated:
- when the vehicle speed is above approximately 6 mph (10 km/h);
- depending on the vehicle, when the vehicle is stationary for more than approximately five seconds and an obstacle is detected (such as when in a traffic jam, etc.);
- when you are in N or P position;
- when an operating fault is detected.
Note: depending on the vehicle, if the vehicle is fitted with a towbar recognised by the system, only the rear parking distance control function is deactivated.
Adjustment
warning
For safety reasons, carry out any adjustments while the vehicle is stationary.
tip
Each time the vehicle is started, the function resumes the activation status that was saved the last time the engine was stopped.
Adjusting settings from the multimedia screen 4
With the vehicle stationary, from the "Vehicle" world on the your multimedia screen 4, press the "Parking assistance" menu.
Please refer to the multimedia instructions for further information.
Deactivating the system sound
(depending on the vehicle)
Activate or deactivate the parking distance control sound.
Note: if you mute the sound, when approaching an obstacle you will be alerted only by the display.
Parking distance control audio volume
Adjust the parking distance control volume using the volume bar.
tip
Each time the vehicle is started, the function resumes the activation status that was saved the last time the engine was stopped.
Special cases
You can manually deactivate sound alerts or, depending on the vehicle, the detection zone concerned in the event that:
- towing, carrying or trailer equipment that is unrecognised by the system is present in front of the ultrasonic sensors;
- the ultrasonic sensors are damaged.
Note: if the sound is deactivated, the displays will continue to alert you repeatedly.
Operating faults
When the system detects an operating fault:
- either a beep sounds for approximately three seconds when the reverse gear is engaged, accompanied by the "Check Parking sensors" message on the instrument panel;
- or the system does not produce any sound (unless deliberately deactivated) or there is no display when the reverse gear is engaged.
Check that the ultrasonic sensors are clean. If it the fault persists, consult an approved Dealer.
tip
When the vehicle is travelling at a speed below approximately 6 mph (10 km/h), some noises (motorcycle, lorry, pneumatic drill, etc.) may trigger the Park Assist system audible warnings.
Recommendations
tip
System servicing/repairs
- In the event of an impact, the alignment of the ultrasonic sensors may be altered and its operation may consequently be affected. Deactivate the function and consult an approved Dealer.
- Any work in the area where the ultrasonic sensors are located (repairs, replacements etc.) must be carried out by a qualified professional.
Only an approved Dealer is qualified to work on the system.
Cases of system disruption
Some conditions may disrupt or damage the system operation, for example:
- poor weather conditions (rain, snow, hail, black ice, etc.);
- some types of noise (motorcycle, lorry, jackhammer, etc.);
- fitting an non-compatible towing ball or hook.
Risk of false warnings or absence of warnings.
If the system behaves abnormally contact an authorised dealer.
Limitation of the system operation
- The ultrasonic detection zones should be kept clean and free of any modifications in order to ensure the proper operation of the system.
- Small objects moving close to the vehicle (motorcycles, bicycles, pedestrians, etc.) may not be recognised by the system.
- The system may not detect obstacles that are too close to the vehicle.
- The system may not provide a warning when the other vehicles or obstacles are travelling at a significantly different speed.
- If the trajectory is modified during a manoeuvre, the system may report obstacles with a delay.