Dacia Striker

まで 今日

Using information from the 1 camera, the function triggers corrective action on the vehicle steering system when a continuous or broken line is crossed or when approaching the roadside (divider, barrier, pavement, embankment, etc.) without activating the direction indicator lights.

Depending on the setting, in the event of crossing a broken line without activating the direction indicator lights, the function:

  • warns the driver without corrective action on the steering system;

or

  • performs corrective action on the steering system.
tip
You can retake control of the vehicle at any time by operating the steering wheel.

Location of the camera 1

Make sure the windscreen is not obscured (by dirt, mud, snow, condensation etc.).

warning

This function is an additional driving aid. This function is not under any circumstances intended to replace the due care and attention of the driver, who should at all times be in control of the vehicle.

Activation/deactivation

tip

Depending on the vehicle, according to the length of time following the last time the engine was stopped, the function is reactivated:

  • when the vehicle is unlocked;

or

  • when a door is opened;

or

  • when the engine is restarted.

Activating, deactivating the system from the multimedia screen 2

Please refer to the multimedia instructions for further information.

Activating, deactivating the system using the switch 3My Safety

The function can be deactivated or activated using the "Perso" mode of the "My Safety" function My Safety. If the function has previously been deactivated from "Perso" mode:

  • To deactivate the function, if it has previously been deactivated from the "Perso" mode of the "My Safety" function My Safety, press twice on the switch 3. The warning light is displayed in yellow on the instrument panel.
  • To reactivate the function, press the 3switch once. Warning light 2_ALL_377_1_pictogramme.png comes on the instrument panel.

Operation

When the function is activated, the 2_ALL_377_1_pictogramme.png warning light and the left-hand and right-hand line indicators 4 are displayed in grey on the instrument panel.

The function is ready to warn or intervene when the speed is between approximately 40 mph (65 km/h) and 106 mph (170 km/h) and the 2_ALL_377_1_pictogramme.png warning light and the right-hand or left-hand line indicators 4 appear in white on the instrument panel.

The function intervenes if the vehicle:

  • approaches a roadside without activation of the direction indicators;
  • crosses a continuous line without activation of the direction indicators;
  • crosses a broken line without activating the direction indicators, if the "Operation on broken line" setting is selected.

In these cases:

  • the function triggers an action on the vehicle's steering system to correct the vehicle trajectory;

and

  • the 2_ALL_377_1_pictogramme.png warning light appears in yellow and the indicator 4 on the side of the breached line changes to yellow on the instrument panel.

If the corrective action on the steering system is not sufficient, the 2_ALL_377_1_pictogramme.png warning light appears in red and the indicator light 4 on the side of the breached line changes to red on the instrument panel. This is accompanied by a vibration on the steering wheel.

If the "Dashed line intervention" setting is not selected, the function sounds the alarm if the vehicle crosses a broken line without activation of the direction indicators and there is no roadside close enough to the line.

In this case, the function warns the driver:

  • by a vibration in the steering wheel;

and

  • the 2_ALL_377_1_pictogramme.png warning light appears in red and the indicator 4 on the side of the breached line changes to red on the instrument panel.

Note: when driving through a bend, the function enables the bend to be cut slightly.

Special case

"Keep control" warning

  • If the system is in operation and does not detect any action by the driver on the steering wheel, the "Keep control" message appears on the instrument panel accompanied by a beep and the 2_ALL_360_1_pictogramme.png warning light appears in yellow until the driver has regained control of the vehicle.
  • If the system has been in operation for too long, the "Keep control" message appears on the instrument panel accompanied by a beep and the 2_ALL_360_1_pictogramme.png warning light appears in yellow accompanied by the flashing of indicator 4 on the side of the relevant line until the driver has regained control of the vehicle.
tip
You can interrupt the trajectory correction at any time by moving the steering wheel.

Function temporarily unavailable/inhibited

The system is temporarily unavailable or disabled when:

  • very fast lane departure;
  • driving continuously on a line;
  • approximately four seconds after changing lanes;
  • tight bends;
  • impaired visibility;
  • one of the direction indicators is activated;
  • activating the hazard warning lights;
  • engaging reverse gear;
  • strong acceleration;
  • the lane width changes;
  • intervention of the anti-lock braking system;
  • intervention of the Electronic Stability Control ESC;
  • intervention of the anti-lock braking system.

If the function is unavailable, the 2_ALL_377_1_pictogramme.png warning light and left-hand and right-hand correction indicators 4 change to grey on the instrument panel.

When the front camera is obscured, the "Front camera no visibility" message is displayed on the instrument panel. Clean the area where the sensors are located.

Automatic deactivation

The function is automatically deactivated when:

  • the Electronic Stability Control ESC is deactivated or malfunctions;
  • the anti-lock braking system is malfunctioning;
  • a towbar is electrically connected to the trailer hitch socket;
  • the 2_ALL_116_1_pictogramme.png warning light is displayed.

When the function is deactivated, the warning light is displayed in yellow on the instrument panel.

Settings

Settings from the multimedia screen 2

Using the switch 3

To access the multimedia screen function settings 2, refer to the multimedia instructions:

  • « Dashed line intervention » : use this setting to select the function's response if the vehicle crosses a broken line without activation of one of the direction indicators:
    • Setting selected: the function may intervene on the steering system to correct the vehicle's trajectory;
    • Setting not selected: the function may alert the driver by means of a vibration on the steering wheel, without correcting the vehicle's trajectory.
  • « Vibration » : adjust the intensity of the "Lane departure prevention" vibration on the steering wheel;
  • depending on the vehicle, "Lane exit anticipation" or "Warning": adjust the line detection sensitivity level. To do this, select:
    • « Late » : line detected upon crossing;
    • « Standard » : line detected on approach;
    • « Early » : line detected nearby.

Please refer to the multimedia instructions for further information.

Operating faults

When the system detects an operating fault:

  • the warning light is displayed in grey on the instrument panel;

In some cases, they are accompanied by:

  • the "Driving assist unavailable" message;

or

  • the "Check Driving assist" or "Check Front camera" message.

Consult an Approved Dealer.

Warnings

warning

This function is an additional driving aid. This function is not under any circumstances intended to replace the due care and attention of the driver, who should at all times be in control of the vehicle.

System servicing/repairs

  • In the event of an impact, the camera alignment may be changed, and its operation may consequently be affected. Deactivate the function and consult an authorised dealer.
  • Any work in the area where the camera is located (repairs, replacements, windscreen modifications etc.) must be carried out by a qualified professional.

Only an authorised dealer is qualified to service the system.

In the event of system disturbance

Some conditions can disturb or damage the operation of the system, such as:

  • windscreen obscured (by dirt, ice, snow, condensation etc.);
  • a complex environment (tunnel, etc.);
  • poor weather conditions (snow, rain, hail, black ice, etc.);
  • poor visibility (night, fog, etc.);
  • the road markings are multiple (roadworks, etc.), difficult to distinguish or irregular (e.g. partially faded lines, lines too far apart, uneven road surface, etc.);
  • being dazzled (glaring sun, lights of vehicles travelling in the opposite direction; etc.);
  • the road is narrow, winding or undulating (tight bends, etc.);
  • closely following a vehicle travelling in the same lane.

In this case, the "Lane departure prevention" function may be activated incorrectly or not at all.

Risk of unwanted, incorrect correction or no correction of trajectory.

Deactivating the function

You must deactivate the function if:

  • the area of the camera has been damaged (on the windscreen side or the interior rear-view mirror side);
  • the road is slippery (snow, black ice, aquaplaning, gravel etc.);
  • the windscreen is cracked or distorted (do not carry out windscreen repairs in this area; have it changed by an approved dealer);
  • the vehicle is towing a trailer or a caravan.